approach path

英 [əˈprəʊtʃ pɑːθ]

美 [əˈproʊtʃ pæθ]

进场航线

电力

英英释义

noun

• the final path followed by an aircraft as it is landing
  Synonym:approachglide pathglide slope

双语例句

• A new approach for path planning of mobile robot in a dynamic environment
  动态环境下移动机器人路径规划的一种新方法
• In this paper a graphic approach to the path planning problem based on the topological method is discussed.
  本文提出一个解决基于拓扑的路径规划问题的新途径：图形法。
• Firstly the principle to select path in local area with different threats is established, and a new approach to create the path diagram by different threats is presented.
  从理论上建立了具有不同威胁体的局部空域路径选择原则，给出了根据不同威胁体建立相应路径图的步骤和方法。
• The problems of the approach glide& down path holding and longitudinal control are particularly discussed. At the same time, the ways to calculate the feedback control loop parameters for automatic flight control system and approach power compensator system are given.
  着重讨论了舰载飞机在进场下滑过程中的轨迹保持及其纵向控制，同时给出了此时飞机的飞行自动控制系统和进场功率补偿器系统反馈控制参数的计算方法。
• Approach to the shortest path in route network
  道路网络中最短路径的算法与实现
• An algorithm that combines this approach with critical path tracing ( CPT) is also introduced and jt simplifies the processing procedure of the criticality computing of fanout stems in CPT.
  本文还介绍了本算法和临界路径跟踪法相结合的一种算法，简化了临界路径跟踪法中对扇出源临界性的处理过程。
• Chapter 4, according to the shortage of the algorithm provided in the chapter 3 and removing the influence of unsureness sensors information, a feasible mixed approach of path planning is discussed.
  第四章针对第三章提出算法的缺点，排出不确定传感器信息的影响，试验一种随机规划与局部路径规划相结合的混合路径规划方法。
• This paper describes a new approach to robot path planning: the transition cost matrix based approach.
  本文描述了机器人路径规划的一种新方法：基于转移费用矩阵的机器人路径规划方法。
• Finally, the two path planning approaches are elaborated differently, which are the Genetic Simulated Annealing path planning approach based on hierarchical model and the local path planning approach based on radar path planner.
  最后，本文分别详细介绍了全局路径规划和局部路径规划两个算法：基于分层模型的遗传模拟退火算法路径规划和基于雷达法的局部路径规划。
• Finally, a new approach for cutter path calculation using binary-search technique is presented, which will simplify the CNC programming problems to a great extent.
  最后提出一种采用对分试算法计算刀具轨迹的新方法，可简化数控编程计算问题。